Efapel 40213 Manual Del Usuario página 20

CONNECT THE SWITCH TO THE NETWORK -
1 STEP
ST
Press RESET 7 seconds
until all the LEDs are
at half brightness.
2 STEP
ND
Click on PROG.
3 STEP
RD
Click on the com-
mand button of the
Installation Key (Ref.
40925) in close prox-
imity to the Switch.
20
ONLINE
1.1 - The LED ON
switches on.
2.1 - The LED ON
starts
indicating that it is
ready to be added
to the
during a period of
10 seconds .
3.1 - The LED starts to
blink red, indicating
that it is searching for
the device that is going
to be added.
3.2 - The LED blinks
green and switches
off, the device's LED
ON switches off and
the A, B, D, C LEDs
switch on and off in
sequence,
that the Switch was
successfully added to
the network.
Note: If the Installation Key LED
does not turn green and switch
off, repeat from the 1
to blink,
network,
indicating
step.
st