Whittier Wood Furniture 327Wb Instrucciones De Ensamblaje página 3

Tools Required: Phillips Screwdriver, 9/16" Wrench, Rubber Mallet or Padded Hammer, Wood Glue
We recommend that you apply a finish before you assemble this unit.
Cb
1. Position the Legs (Cb, Fb and Bb) and Side Stretchers (Gb) as shown in Figure 1. NOTE: Be sure the
insert holes on the corners of the legs face inward. Spread a thin layer of glue in the dowel holes
and insert Stretchers (Gb). With a damp rag, quickly wipe off any excess glue.
S x 4
T x 4
T
S
Fig. 2a
2. Place the Top Assembly (Ab) upside-down on a clean, protected surface. Spread a thin layer of
glue in the remaining dowel hole in each Back Leg (Fb) and insert Back Stretcher (Db) as shown in
Figure 2. Position leg/stretcher assembly outside and against the corners of the aprons. Insert a
3/8" x 2-1/2" Hex Bolt (S) with a Washer (T) through the corner brace and into the Insert Nut in each
leg. See Figure 2a.
327Wb Mission Writing Desk
Assembly Instructions
Before doing so, please read the enclosed Finishing Hints.
Gb
Fb
Ab
IMPORTANT:
Fb
Fig. 2
Db
Gb
Bb
Fig. 1
Fb
Page 3 – 327Wb – 06/10