Publicidad
Idiomas disponibles
Idiomas disponibles
8
6. Follow the procedures described in section "ASSEMBLY" to reassemble the backrest
7. Make sure that the actuator is in its shortest position. Rotate the actuator to set the
backrest to its final reclined position as shown in fig.4, and lock the roller shaft into
the actuator locker
8. Align and slide the battery pack onto the battery seat on the backrest as shown in fig.5
to connect the battery pack. Lift the clip on the lower portion of the battery pack and
pull it away from the battery seat to disconnect.
fig.5
WARNING!
• Do not connect the battery pack to the bath lift until it is assembled
and is set to its reclined position in the bath
• The battery pack MUST be fully charged before use
A - Battery pack
B - Battery pack compartment
Publicidad
