Publicidad
Idiomas disponibles
Idiomas disponibles
10
EMERGENCY STOP
If the handled controller buttons do not respond while the bath lift needs to be
stopped, press the emergency stop button on the handled controller. A red led
will be illuminated and the bath lift will stop immediately. To operate the bath lift,
press this button again to release it
10.4 Removing the bath lift from the bathtub
1. Let the water leak out of the bathtub
2. Always remove the bath lift from the bathtub in two sections: backrest and unit base.
Gently fold the backrest over until it touches the seat in order to unlock
the actuator from its locker
3. Raise it again straight and you can lift it away
4. Fold the side flippers onto the seat
5. Lift the bath lift with the front handle and pull to release
the front suction pads. Gently tilt the bath lift by the front handle
DO NOT RELASE STRAP OF THIS HANDLE
6. Lift the rear side of the bath lift by pulling the rear handle.
7. Then lift the bath lift away from the bathtub with two hands.
10.5 Recharge the battery
WARNING!
• When recharging always use a socket away from the bathroom and recharge
in a dry environment
• The batteries are rechargeable and replaceable
• Disposal of battery pack: please conform to local regulations
fig.7
Note:
•
For new battery, the first charge shall be no less than 8 hours
•
Recharge the battery as soon as possible after each use. DO NOT overcharge it for more than 24 hours
•
Disconnect the battery pack form the bath lift while not in use. Store it in a cool dry place
•
Use only battery charger which comes with your bath lift
•
To increase the battery life, recharge it at least once a month if you don't use the device
for extended period of time
Follow the following procedures to recharge your
battery pack:
1. Remove the battery pack from the bath lift
2. Plug the charger into the charging
socket on the battery pack, fig.7
3. Plug the charger into a suitable power supply
(220 VAC/50 Hz)
Publicidad
