Publicidad
Idiomas disponibles
Idiomas disponibles
16
The bath lift RS900 is intended for use in electromagnetic environment in which the radiated
RF disturbances are controlled. Mobile RF communications equipment (transmitters) can af-
fected the bath lift. However, the customer or the user of the above mentioned product can help
prevent electromagnetic interferences by maintaining a minimum distance between portable
and mobile RF communications equipment (transmitters) and the bath lift as recommended
below, according to the maximum output power of the communications equipment.
Rated maximum
output power of
transmitter W
150 KHz to
80MHz d=1.2P
0.01
0.1
1
10
100
For transmitter at a maximum output power not listed above, the recommended separation
distance d in meters (m) can be estimated using the equation applicable to the frequency of
the transmitter, where P is the maximum output power rating of the transmitter in watts (W)
according to the transmitter manufacturer.
Note 1
- at 800Mhz and 800Mhz, the higher frequency range applies
Note 2
- these guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structure, objects and people.
17. SPARE PARTS/ACCESSORY
For spare parts only make reference to Moretti master catalogue
18. WARRANTY
Moretti products are guaranteed from material or manufacturing faults for 2 years from
the purchasing date, except possible exclusion or restriction as follows. The warranty
shall not be apply in the event damages caused by improper use, abuse or alteration, and
for the warranty will not be valid if the instructions for use are not strictly adhered to.
The correct intended use is specified in this manual.
Moretti is not responsible of consequent damages, personal injuries or whatever caused
by or in relation with mistaken installation or with device improper use.
Moretti does not guarantee for damages caused by the following condition: natural di-
saster, not authorized maintenance or repairs , faults caused by problems on electricity
supply (when necessary), use of spare parts not covered by Moretti, improper use, alte-
ration not authorized, shipment damages (different from original Moretti shipment), or in
case of insufficient maintenance as indicated in the manual.
Separation distance according to frequency of transmitter m
80MHz to
800MHz d=1.2P
0.12
0.38
1.2
3.8
12
800MHz to
2.5 GHz d=2.3 P
0.12
0.38
1.2
3.8
12
0.23
0.73
2.3
7.3
23
Publicidad
