Publicidad
Idiomas disponibles
Idiomas disponibles
•
Keep the package or dispose according to regulations.
•
Do not leave parts of the packaging in an accessible location (e.g.
tinfoil, cardboard, etc.). These elements pose a suffocation hazard to
the child.
1.
List of parts:
2.
Assembly instructions:
Handlebar
Start the assembly by removing screws of the handlebars assembly clamp (Fig. 1), then place the
handlebars(E) as shown in Fig. 2A, place the other part of the clamp and place the screws. Tighten
the screws using the assembly spanner (H), clockwise, until resistance is felt (Fig. 2B).
Seat
Using the assembly spanner (H) loosen the seat clamp (B) to place the seat inside (Fig. 3A). Next,
slide the seat (F) into the hole and tighten using the Allen key (Fig. 3B) - clockwise, until resistance
is felt.
Note!
•
The seat level should be adapted to the height of the child, at the same time making sure the
minimum level mark is inside the pipe (Fig. 4)!
•
The maximum position of the seat is indicated as position 9 on the seat pipe, using the MAX
mark – Fig. 5!
•
The seat level must be adjusted by an adult only.
Wheels
Begin the assembly of wheels (D) by removing the protector, the nuts and washers (Fig. 6A). Next,
slide the wheel into the fork openings (Fig. 6B), place the washers (Fig. 6C) and nuts. Tighten the
elements using the spanner (G).
The correctly assembled product is shown in Figure 7.
Remember to make sure before the assembly and before each use that all connectors (nuts) are
correctly tightened and whether the tyres are inflated correctly.
3.
Cleaning and maintenance:
In order to ensure safe use, the bicycle should be cleaned regularly using a soft sponge/cloth and
soapy water, followed by wiping the product dry.
Do not use aggressive chemicals to clean the product, as they may damage the product. Use
grease (or anti-corrosion spray) regularly on rotating product parts, check the screws and parts
for correct tightening. Replace damaged parts, if necessary. Store the product away from moisture
and extreme temperatures. Do not leave the product exposed to weather conditions, i.e. rain, snow
or high temperatures.
no.
A+B+C
The frame with the installed front fork (A), the
seat clamp (B) and the handlebars assembly
D
Wheels with installed washers and nuts
E
Handlebar with the bell installed
F
G+H
element
clamp (C )
Saddle
Assembly wrench
9
Publicidad
