Trust AGC-200 Guia Del Usuario página 6

EN
AGC-200 WATERPROOF SOCKET DIMMER
1. Place Dimmer
A
Connect the lamp to the dimmer and place the dimmer
in a socket outlet.
B
The dimmer pairing mode will be activated. Pairing
mode lasts for 6 seconds.
2. Pairing the dimmer with a transmitter
Send an ON signal within 6 seconds with a Trust Smart
Home transmitter during pairing mode. The dimmer can
store up to 32 different transmitters in its memory. The
paired transmitters are kept if the dimmer is moved to
another socket outlet.
3. Control the dimmer
A
Press the ON button with the assigned channel on the
paired transmitter to turn on the dimmer/lamp. Do not
exceed the maximum load: 200W.
B
Press the OFF button with the assigned channel on the
paired transmitter to turn off the dimmer/lamp.
Should your lights vibrate check whether your lamp is
dimmable or try another dimmable lamp.
4. Set dimming range
Each type of lamp (incandescent lamp, halogen or
dimmable LED lamp) has a different dimming range.
Therefore you can set a lowest dimming value for the type
of lighting that is connected.
A
Put the dimmer in pairing mode. (See chapter 1)
B
During pairing mode, press and hold the ON button
for 3 seconds. (for the ACCT-510 and ACST-9900 the
ON-OFF button).
C
The lamp will flash 2x to confirm that the dimming
range can be set
6
D
Give an ON signalwith the paired transmitter to increase
the dim level 1 step. Give an OFF signal to decrease the
dim level 1 step.
E
When the desired dimming range has been selected,
press and hold the ON button for 3 seconds. (for the
ACCT-510 and ACST-9900 the ON-OFF button)
F
The connected lighting will flash 2x and dim to the
lowest dim level as confirmation that the dimming
range has been saved
5. Activate dimming sequence
A
Press the ON button of a paired transmitter to turn on
the receiver.
B
Press ON again to start the dimming sequence activate
C
Press ON a third time to lock the desired dimming level.
The dimming sequence will stop and lock automatically at
the highest or lowest point when no signal is given with
a transmitter.
Optional: Remove transmitter from dimmer
A
Remove the dimmer from the socket outlet. After 6
seconds, plug the dimmer back into the socket outlet.
B
The pairing mode will be activated for 6 seconds. Send
an OFF signal within 6 seconds with a paired channel of
the Trust Smart Home transmitter to unpair it.
C
The connected lamp will flash 2x to confirm unpairing.