Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
B3. ATTACHING THE MOUNTING PLATE
TO THE WALL
□
Attach the plate to the wall using toggle bolts. At least one wood
screw must be used to attach the plate to a wall stud.
□
Remove the toggle wings from the bolts.
□
Insert the bolts into the mounting plate through the holes
designated to go into drywall and reattach the toggle wings to
3/4 in. (19 mm) onto each bolt.
To use toggle bolts:
Toggle Wings
Mounting
Plate
Wall
□
Place the mounting plate against the wall and insert the toggle
wings into the holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screws,
make sure the bottom of the mounting plate touches the
bottom of the cabinet when pushed flush against the wall and
that the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers between the
back of the mounting plate and the wall.
□
Tighten all bolts. Pull the plate away from the wall to help tighten
the bolts.
B4. USING TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
□
You need to drill holes for the top support screws and a hole large
enough for the power cord to fit through.
Spacing for Toggles More
Than Wall Thickness
Toggle
Bolt
Bolt End
□ Read the instructions on the TOP CABINET TEMPLATE.
□ Tape it underneath the top cabinet.
□ Drill the holes, following the instructions on the TOPCABINET
TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the
cabinet bottom.
B5. ADAPTING MICROWAVE BLOWER FOR
OUTSIDE BACK EXHAUST
□
Remove and save screw that holds blower motor to microwave.
□
Carefully pull out the blower unit. The wires will extend far
enough to allow you to adjust the blower unit.
Before: Fan Blade
Openings Facing
Forward
End A
□
Roll the blower unit 90°.
Before Rotation
Back of
Microwave
18
Blower Motor
Back of
Microwave
Blower Motor
Screw
End B
After Rotation
Back of
Microwave
Publicidad
