Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1 . UNPACKING THE BOX
□
Remove the installation instructions (C), use and care guide (D),
exhaust adapter (F), shelf (J), filters (E), glass tray (G), turntable
ring (H), and the small hardware bag
Styrofoam™ protecting the front of the oven.
NOTE: Do Not Remove plastic plug protective cover
until just before hanging the unit.
(L)
(E,H)
□
Fold back all 4 carton flaps fully against carton sides.
□
Carefully roll the oven and carton over onto the top side.
□
The oven should be resting in the Styrofoam.
Styrofoam
□
Pull the carton up and off the oven.
□
Cut the middle of the outer protective plastic bag to remove the
mounting plate.
(K)
□
Remove screws from each end of the mounting plate ( K ) .
This plate will be used as the rear wall template and for
(L) Do not remove the
.
(F)
(G)
Carton
mounting. Reinstall the screws into the holes where they
were removed.
2
. FINDING THE WALL STUDS
Wall
Studs
Center
□
Find the studs, using one of the following methods:
□
Studfinder – a magnetic device which locates nails.
□
Use a hammer to tap lightly across the mounting surface to find
a solid sound. This will indicate a stud location.
□
After locating the stud(s), find the center by probing the wall
with a small nail to find the edges of the stud. Then place a mark
halfway between the edges. The center of any adjacent studs
should be 16 in. (40.6 cm) or 24 in.(61 cm) from this mark.
□
Draw a line down the center of the studs.
IMPORTANT: The microwave must be connected to
at least one wall stud.
3
. DETERMINING WALL PLATE LOCATION
Plate position-beneath cabinet bottom
B
in.
□
Draw a vertical line on the wall at the center of
the 30 in. wide space. T ape t he R ear Wall T emplate (B) onto
the wall matching the center line and touching the bottom of
the cabinet.
8
in.
in.
Publicidad
