Sanding Cuts And Sandpaper - Clarke American Sanders OBS-18 Manual Del Operador

ENGLISH
EN
revised 6/12

SANDING CUTS AND SANDPAPER

Initial Cut
The purpose of the initial cut is to remove old fi nish and gross imperfections on the fl oor surface. Use a course
(20-36 grit) grain abrasive.
Final Cuts
The purpose of a fi nishing cut is to remove the scratches produced during the initial cut. Use a fi ne (60-80 grit)
grain abrasive. If the surface remains rough after a fi nishing cut, it may be necessary to use an even fi ner grain
of abrasive (80-100grit). Care should be taken in selecting the grit size of the abrasive. A very fi ne grain will
close the pores on a wood fl oor making admission of a stain diffi cult.
If glazing or burning should occur the abrasive has dulled and must be replaced.
®
American Sanders Operator's Manual (EN) - OBS-18/18DC FORM NO. 70288B -9-
Clarke