Publicidad
Idiomas disponibles
Idiomas disponibles
Do not burn
Batteries may enter water cycle if disposed
improperly, which can be hazardous for
ecosystem. Do not dispose of waste batteries
as unsorted municipal waste.
For indoor use only (for charger)
T 3.15A
Fuse
Positive terminal
Negative terminal
Double insulation (for charger)
Risk of high temperature
Class III appliance
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for:
1) Inflating high pressure items like motorcycle, car, and
bicycle tires
2) Inflating and deflating low pressure items like air
mattresses, rafts and floats.
• Make sure the intake air is dry and dust free.
• Do not install or use the air pump in a damp or wet room.
• The air pump may only be used in suitable room (with
good ventilation and an ambient temperature from + 5
to 40
C). There must be no dust, acids, vapors, explosive
O
gases or inflammable gases in the room.
• The air pump is designed to be used in dry rooms. It is
prohibited to use the air pump in areas where work is
conducted with sprayed water.
• Operate the air pump only on a firm, level surface.
EN
ASSEMBLY
1. FITTING THE ACCESSORIES FOR
INFLATOR (SEE FIG. A1, A2)
1) Open the lock lever of valve adaptor, insert the sport
ball needle /tapered adapter/presta valve adapter into
the valve adapter of high-pressure air hose.
2) Rotate the sport ball needle /tapered adapter/presta
valve adapter clockwise into the valve adapter of
high-pressure air hose.
3) Press the lock lever of valve adaptor down to lock
the sport ball needle /tapered adapter/presta valve
adapter firmly.
2. FITTING THE ACCESSORIES FOR
BLOWING (SEE FIG. B1, B2)
1) Align the two grooves on the connector of low-
pressure air hose with the bulge on the outlet.
Insert the low-pressure air hose to the outlet on the
machine.
2) Rotate the low-pressure air hose anti-clockwise to
lock.
3) Insert the small head adapter into the end of the low-
pressure air hose.
3. FITTING THE ACCESSORIES FOR
SUCTION (SEE FIG. C)
Insert the low-pressure air hose into the inlet for suction.
BEFORE PUTTING INTO OPERATION
1.POWER SUPPLY SWITCH AUTOMATICLY
Select the power supply according to the working
condition.
When the car cigarette lighter is connected, the cigarette
lighter can be used for power supply. While the battery
pack is connected, the battery pack can be used for
power supply.
2. POWER SUPPLY WITH BATTERY PACK
- CHARGING YOUR BATTERY PACK
(CHARGER AND BATTERY PACK NOT
SUPPLIED FOR WS2961.9)
Do not use any charger other than that specifically provided
for use with the equipment. If the battery pack is very hot
you must remove your battery pack from the charger and
allow time for the battery to cool down before recharging.
C
O
Please charge the battery to reach full before storage. If
the tool will not be used for long periods of time, charge the
battery every 3 months.
- CHARGING PROCEDURE (SEE FIG. D)
1) Plug the charger into an appropriate outlet. The light
will be green.
17
Publicidad
