Publicidad
Idiomas disponibles
Idiomas disponibles
Complete the Add-On Unit by adding two Long Z-beams
(part B) at the top keyholes of the Angle Posts (part A) and
inserting two Long Z-beams (part B) into the 7th and 8th
keyholes from the bottom of the Angle Posts. As shown in
the illustration. Install all Z-beams in the upright position.
Hit the beams near the joint with a rubber mallet to lock
joints into place.
To secure the frames together align the four middle
Angle Posts (part A) of the frames as shown. Start with
the two back middle Angle Posts. Align the indents on
the Post Clips (part G) with two keyholes of the back
middle Angle Posts. Firmly clamp together a Post Clip
and the two angle posts. Repeat the step to clamp the two
front middle angle posts.
Note: To remove Post Clips use a screwdriver.
Insert the Post Caps (part E) on the top of the Angle Posts
(part A) as shown.
Now lay the Shelf Decks (part D) in between the Z-beams as
shown.
Periodically inspect the unit to ensure all Z-beams are seated
properly and firmly connected to the Angle Posts.
Page 6 of 7
D
D
Shelf Deck
Upright
Position
(Z-beam)
Publicidad
