ATH-Heinl 55HAP Manual De Instrucciones página 104

Make sure that the supply voltage of the electrical system corresponds to the voltage indicated on the motor
nameplate.
Make sure that the electrical connections are in accordance with the plans.
Make sure that there are no leaks or bubbles in the hydraulic and pneumatic lines.
Make sure that the lift is grounded
Make sure the work area is clear of people and objects
Make sure all sliders are in proper position and properly greased
Make sure all bolts are properly installed and lubricated
Use only recommended hydraulic fluid
Fill hydraulic fluid to the top mark on the reservoir cap. Raise and lower the lift, then refill with hydraulic oil.
(Approx. 18 liters in total)
Attention
It is strictly forbidden to operate a 60Hz motor on a 50Hz power supply. Never operate the
motor at a voltage lower than 208V. This may result in motor damage.
Make sure that the direction of rotation of the motor corresponds to that indicated on the arrow plate of the
motor by pressing the Lift button
2.9.2.10 Oil supply and venting of the platforms
1. Press the LIFT button to bring the oil into the system
If the hoist ropes are not tight, it means that the switch monitoring the hoist ropes is open. Press the override
switch , located inside the control box, until the switch is active.
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
104
1
Release date: 16.03.2023 / Product manufacturer ATH-Heinl GmbH & Co. KG