Skil 9295 Manual Del Propietário página 14

Disc Grinding Wheel Assembly
Disconnect tool from power source. Be sure that wheel guard is in place for grinding. Place
BACKING FLANGE and GRINDING WHEEL on the spindle. Thread on the lock nut and tight-
en nut using the supplied lock nut wrench, while holding the spindle lock in (Fig. 3).
TO REMOVE: Reverse procedure.
Grinding
Wheel
Sanding Accessories Assembly BACKING PAD
WARNING
WARNING
To Install Backing Pad And
Sanding Disc
Disconnect tool from power source. Set the tool
on its top side (spindle up). Place the rubber
backing pad onto the spindle shaft. Center the
sanding disc on top of the backing pad. Insert
the lock nut through the disc and thread onto
the spindle as far as you can with your
fingers. Press in the spindle lock, then tighten
the backing pad securely with lock nut wrench
(Fig. 4).
14
Spindle
Backing
Flange
Lock Nut
Before attaching a backing pad be sure its maximum safe operating speed
is not exceeded by the nameplate speed of the tool.
Wheel guard may not be used for most sanding operations. Always rein-
stall wheel guard when converting back to grinding operations.
Fig. 3
Spindle
Fig. 4
Spindle
Wheel
Guard
Backing
Flange
Grinding
Wheel
Lock Nut
Backing
Pad
Sanding
Disc
Lock Nut
Wire Brush