Skil 9295 Manual Del Propietário página 22

TROUBLE SHOOTING
WARNING
Trouble
Tool will not start
Tool does not come
up to speed
22
Read instruction manual first! Remove plug from the power source before
making adjustments or assembling accessories.
Problem
1. Power cord is not plugged in.
2. Power source fuse or
circuit breaker tripped.
3. Cord damaged.
4. Burned out switch.
1. Extension cord has
insufficient gauge or is too
long.
2. If equipped with variable
speed, tool may not set at
maximum RPM.
3. Low house voltage.
Remedy
1. Plug tool into power source.
2. Replace fuse or reset tripped circuit
breaker. (If the product repeatedly
causes the circuit or fuse to trip/blow,
discontinue use immediately and
have it serviced by an Authorized Skil
Service Center or Service Station.)
3. Inspect cord for damage. If damaged,
have cord replaced by an Authorized
Skil Service Center or Service Station.
4. Have switch replaced by an
Authorized Skil Service Center or
Service Station.
1. Replace with adequate extension
cord.
2. If equipped with variable speed, check
speed setting.
3. Contact your electric company.