Bulldog DC Serie Manual De Instrucciones página 11

1.6 Know your Wireless Remote
WARNING
Never lose sight of the winch or jack while using the wireless remote.
Never touch the winch or jack while the remote is in someone else's hands.
Wireless Switch Cord W/3Pin plugs
Receiver Ø8 X 1500 mm
1.6.1 Wireless Remote and Transmitter Specifications
1. Transmission range:15 ~ 27 m (50 ~ 90 ft)
2. Receiver operation voltage: 8 ~ 24 V
3. Receiver fuse current rating: 7.5 A
4. Protection: IP-66
5. Operating temperature range: -20°C ~ +70°C
6. LED indication: Green light for power on; Red light
for operating; Blinking green for low battery life;
Blinking red light for poor signal received
1.6.2 Wireless Remote and Transmitter Installation
1. Connect The Wiring
Connect the Switch cord W/3 or 6 Pin
plugs to the socket on the control pack.
Connect the Red wire to the positive (+)
terminal of the battery.
Connect the Black wire to the negative (-)
terminal of the battery.
2. Mount the Receiver
The receiver should be mounted in a clear and
dry location.
Mount on a flat surface with at least 2 fasteners
(not included) through the 7 mm mounting holes
on each side of the receiver. Minimum of one
mounting fastener each side
CEQUENT
Installation Instructions
Figure 7 - Wireless Remote Components
PERFORMANCE PRODUCTS, INC. •
™
Wireless Lithium Battery:
Transmitter
F3837-00 REV B (4782) 08/15
Transmitter
3V CR2032
Figure 8 - Wireless Remote
LED Indication
Figure 9 - Connections
Fuse
Black
Figure 10 - Mounting
Strap
Red
11