6. DRY IRONING
1. Set the steam selector to position O (=No Steam).
2. As per washing label of various clothes, set the correct ironing temperature to begin a
ironing.
7. STEAM IRONING
1. Fill water in the iron as per the water-filling methods.
2. Plug the appliance in the socket.
3. If only set thermostat knob to MAX position as per the temperature indicator, steam
iron will be available, otherwise water may leak from the soleplate.
4. It indicates that the temperature has been ready until the indicator light goes off.
5. Set the steam selector correctly, increase steam output by pushing the steam selector
back and decrease steam output by forward.
6. Caution: Synthetic Fabric, Nylon, Synthetic Silk and Silk cannot use the steam iron,
otherwise it will damage the finish of surface.
8. BURST OF STEAM
• This function works well for tough wrinkles and heavy fabrics. By pressing "Burst of
Steam" button,an intense burst of steam is emitted from the soleplate, this can be
very useful when removing stubborn creases. The shot of steam facility can be used
only while ironing with high ironing temperature. For optimal result, there should
be 5 seconds rest between presses of the steam button. To prevent leaking water
from the soleplate does not press the steam button continuously for more than
5 seconds. Also allow at least one minute interval before applying this burst of
steam function.
9. SPRAYING METHODS
• At any temperature by pressing the spray button a couple of times, the laundry can be
damped down. Ensure that there is enough water in the water tank.
10. SELF-CLEANING
• Use the self-cleaning function once every two weeks. If the water in your area is very
hard(i.e, when flakes come out of the soleplate during ironing),the self-cleaning
function should be used more frequently.). Make sure the appliance is unplugged,
set the steam selector to position "O", fill the water tank to the MAX position, do
not put vinegar or other dealing agents in the water tank., select the maximum
ironing temperature, put the plug in the wall socket, unplug the iron when the po-
wer indicator lighter has gone out, hold the iron over the sink, press and hold the