Publicidad
Idiomas disponibles
Idiomas disponibles
4.2
Charging and fitting rechargeable
battery
• Only use the charger supplied with the tool. Only this
charger is suitable for recharging the tool's battery.
Note:
The battery is supplied partially charged on account of
international shipping regulations.
• Before using for the first time, fully charge the battery
(2 − 3 hours) to extend battery life.
• Push the charged battery into the battery holder until it
clicks into place.
• Press the battery release button to remove the battery
and pull it off. When doing so, do not use force.
The battery charge level indicator shows the battery's
remaining capacity when the tool is switched ON. If the
temperature button flashes red after heating up, the
battery has less than 30 % of its capacity and should be
recharged.
4.3
Gluing
The area you are gluing must be free of grease, dry and
absolutely clean. Glue marks on clothing cannot be re-
moved. Drips of glue are best removed when cold.
• Insert glue stick into heating duct.
• When using for the first time, you must press the feed
trigger several times to fill the heating chamber with
glue. It may be necessary to give the glue stick a short
push.
• Press trigger and apply glue to one side.
• Firmly press together the materials being glued, correct-
ing alignment if necessary.
– 25 –
GB
Contents
Publicidad
