Publicidad
Idiomas disponibles
Idiomas disponibles
3. Use the supplied L shape 4-pin connectors to make
corner installations.
4. Verify that all four pins are properly aligned (+12V to
+12V, G to G, R to R, B to B) prior to locking the connector.
Note: If pins are not positioned correctly, the strip will not
turn on.
5. Press rmly to secure both ends of the connector until it
clicks in place.
Note: The light strip has to be properly aligned and fully
inserted into the termination connector to ensure a good
connection.
+
12V
G
R
B
6. Clean the installation surface. Peel o the adhesive tape
and apply. Make sure the area is dry and smooth for
long-lasting results.
12V
7. Proceed to connect and power on the unit. Make sure
that all LED strips light up uniformly. If not, repeat steps 4
through 6.
Factory reset: Press and hold the controller button for
about 5 seconds until the red LED starts blinking. Then
release the button, as it indicates that the strip has been
successfully restored to its factory default values.
+
G
R
B
Publicidad
