Descargar Imprimir esta página

MSW Motor Technics BLS-A001 Manual De Instrucciones página 22

Ocultar thumbs Ver también para BLS-A001:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 82
other condition that may affect the safe operation of the unit). If damaged,
have the unit repaired before use.
e)
Keep the unit out of the reach of children.
f)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
g)
To ensure the designed operational integrity of the unit, do not remove
factory-installed covers or loosen screws.
h)
When transporting or moving the unit from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the unit is used.
i)
Avoid situations in which the machine stops under heavy loads during
operation. This can cause overheating of the drive elements and consequent
damage to the equipment.
j)
Clean the unit regularly to prevent permanent dirt build-up.
k)
The provided value of vibration emission is measured according to the
standard measurement methods. The value of vibration emission may change
if the unit is used under different environmental conditions.
l)
Do not process two workpieces at the same time.
m) The unit is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
n)
Do not start up an empty unit.
o)
Do not tamper with the unit to alter its performance or design.
p)
Keep the unit away from sources of fire and heat.
q)
Do not overload the unit.
r)
During processing of workpieces, attention must be paid to the presence and
safety of bystanders.
s)
Keep a close watch on the workpiece during machining in order to respond in
a timely manner to hazards or to prevent damage to the workpiece.
t)
Keep order and remove all dust, debris and unnecessary parts after the
machining operation.
u)
Keep the material to be processed free from contamination.
v)
Wear protective gloves to avoid injury from sharp edges.
w)
Only use the machine for workpieces according to the specifications in the
technical data table. Do not exceed the permissible workpiece dimensions
x)
Long workpieces must be supported and steadily positioned for processing.
y)
Do not start the cutting operation before the motor has started.
z)
Keep the machine vertical to the workpiece during operation (do not tilt the
machine from side to side, tilting may result in reduced performance and
damage to the cutting blade).

Publicidad

loading