MSW Motor Technics MSW-HB-1500N Manual De Instrucciones página 23

CAUTION: do not lift the vehicle higher than the limit of the unit - see "limited
line" stickers on the feed rods. The ball wire connecting the lift/lower mechanism
to the crank or other tool is designed to break in extreme situations (overloading
or further lifting/lowering beyond factory limits) as a safety precaution against
damage to the unit.
If it breaks, replace it with a new one and you can continue operating the unit.
Lowering
To lower the vehicle, first remove the jacks from under the vehicle (if used), then
release the jack locking pin - it will be damaged if it is not released!
Turn the crank handle or other suitable unit counterclockwise.
Do not rush the lowering of the vehicle, lower it slowly while observing its
movement carefully.
Release the revolutions at the final position as the vehicle begins to settle on the
wheels. Lower the unit completely so that the vehicle can stand securely on its
own wheels and the unit can be easily removed from underneath it.
Transport/storage
The unit must be transported in an almost vertical position with the wheels facing
downwards (see following figure) and held by the connection on the gearbox
side.