Daewoo DCS6524 Manual Del Usuario página 11

EN
HOW TO MIX THE FUEL
1. Measure the amounts of gasoline and oil to be mixed.
2. Put some gasoline into a clean, approved
fuel tank.
3. Pour all of the oil into it and shake vigorously for approximately 30 seconds.
4. Pour in the rest of the gasoline and shake the mixture again for at least one minute.
Be careful, insufficient agitation increases the chances of engine seizure.
5. Place a clear indication or label on the outside of the tank to prevent it from being
confused with a deposit of other substances.
- UNIT SUPPLY
1. Unscrew and remove the fuel cap.
2. Put the fuel into the tank to 80% of the full capacity.
3. Cover the tank with the cap and wipe up any fuel spills on or around the machine.
WARNING!
1. Refuel on flat, clear ground.
2. Move the unit about 3 meters (10 feet) away from the supply point before starting the engine.
3. Stop the engine before refueling the unit. At this time, be sure to sufficiently stir the mixed gasoli-
ne in the tank.
- TO CONTRIBUTE TO THE LIFE OF THE ENGINE, AVOID:
1. Remember not to fill 95 gasoline without oil, this will destroy the engine.
2. Diesel: this can cause serious internal damage.
3. Oil for use in four-stroke engines: it would cause fouling of the spark plug and
the engine blockage among other failures.
4. Mixed fuels that have been left unused for a month or more often have deposits
and will cause carburetor failure.
5. In the case of storing the product for a long period of time, empty the fuel tank
and start the engine several times, allowing
it to turn itself off due to lack of fuel. This will ensure that the fuel circuit, including
the carburetor, is completely drained.
6. In the event of having to dispose of the gasoline mixing tank, do so only at an authorized
site.
- CHAIN OIL
It is essential that for greasing the chain of the chainsaw only use a product specifically
designed for it. In other words, special oil for lubricating chainsaw chains.
Any other oil that is introduced into the chain lubrication reservoir, in the medium-
long term, will damage the lubrication system causing a serious breakdown in the machine.
The machine could also experience excess temperature in the cutting parts which in
turn will transmit the excess temperatureto internal parts of the engine creating major breakdowns
and shortening the life of the machine.
WARNING!
It is very dangerous to work with the chainsaw when the chain or guide bar is
damaged or in poor condition. This can cause damage or even serious injury to the user.
11