Maintenance And Inspection - Metabo HPT SV 12SG Instrucciones De Seguridad Y Manual De Instrucciones

MAINTENANCE AND INSPECTION

WARNING:
1. Emptying and cleaning the dust bag
If the dust bag contains too much saw dust, dust collection will be aff ected. Empty the dust
bag when it gets full.
Remove the dust bag, open the fastener, and dispose of the contents.
2. Inspecting the sanding paper
Since use of worn-out sanding paper will degrade effi ciency and cause possible damage to
the pad, replace the sanding paper as soon as excessive abrasion is noted.
3. Inspecting the screws
Regularly inspect all screws and ensure that they are fully tightened. Should any of the
screws be loosened, retighten them immediately.
WARNING:
4. Inspecting the carbon brushes
For your continued safety and electrical shock protection, carbon brush inspection and
replacement on this tool should ONLY be performed by a metabo HPT AUTHORIZED
SERVICE CENTER.
5. Service and repairs
All quality power tools will eventually require servicing or replacement of parts because
of wear from normal use. To assure that only authorized replacement parts will be used,
all service and repairs must be performed by a metabo HPT AUTHORIZED SERVICE
CENTER, ONLY.
6. Service parts list
CAUTION: Repair, modifi cation and inspection of metabo HPT Power Tools must be
carried out by an metabo HPT Authorized Service Center.
This Parts List will be helpful if presented with the tool to the metabo HPT Authorized Service
Center when requesting repair or other maintenance. In the operation and maintenance
of power tools, the safety regulations and standards prescribed in each country must be
observed.
Be sure to switch power OFF and disconnect the plug from the
receptacle during maintenance and inspection.
Using this orbital sander with loosened screws is extremely
dangerous.
English
15