Toto Ethos Design NII TL690DD Manual De Instrucciones Y Del Propietario página 6

3. Drain installation
 F irst disassemble drain flange
from drain unit
 A pply pipe tape to the flange
threads
 I nsert flange and gasket into
the drain hole
 i nstall the gasket and drain
body onto the flange
secure the drain assembly by
tightening the locknut
insert the plunger into the
flange
 a ssemble the pivot rod as
shown in the diagram
 i nsert the pivot rod into the
plunger hole. Tighten the bolt.
Depending on which lavatory
is installed, if pivot rod hits the
wall, trim from the longer end.
 i nsert the lift rod and pivot
rod into the connecting
block. Tighten both rods with
screwdriver
plunger
gasket
Washer
locknut
pivot rod
hole
Washers
pivot rod
plunger

Drain Flange
gasket
locknut
Drain Body
lift rod
Bolt
Connection
Block