PRESIDENT RONALD Manual Del Usuario página 21

In MENU mode [press F (7) to activate this mode (see § MENU page 22)].
1. Turn rotary PUSH knob (5) to select
2. Press PUSH knob (5) to choose the setting parameter of the selected function.
The parameter blinks on LCD.
3. Turn rotary PUSH knob (5) to change
4. New press PUSH knob (5) permits to
stops blinking and if the function has more than one parameter, the next
parameter blinks.
See § UP/DN KNOBS ON THE MICROPHONE page 22.
6) LCD
Indicates transmission
PA PA (Public Address) mode activated
AM
AM mode selected
FM FM mode selected
ROGER BEEP function activated
BP Beep function activated
Automatic Squelch Control activated
S/RF Bargraph shows the reception S and emission RF level
TALKBACK TALKBACK function activated
ANL ANL filter activated (in AM mode only)
NB
NB filter activated
HI-CUT HI-CUT filter activated
EMG The emergency preset channel activated (9 or 19 by
default)
MENU mode activated
Indicates selected channel (large digits)
Indicates selected band (digits on the right)
Indicates frequency, menus and values of menu
the function to set.
the value of the parameter.
validate the chosen value. The parameter
7) BAND ~ F (Functions)
BAND
(short press)
Press BAND key (7) for quick movement
segments.
See menu BAND NAME page 25.
F (Functions)
(long press)
Long press F key (7) to enter
on LCD.
8) MODE ~ ANL/NB/HIC
MODE
(short press)
Press MODE key (8) to select
the modulation mode: AM or FM. Selected mode
is displayed on LCD.
Your modulation mode has to correspond to the one of your correspondent.
- Frequency Modulation / FM: for nearby communications on a flat open field.
- Amplitude Modulation / AM: communication on a field with relief and ob-
stacles at middle distance (the most used).
NB/ANL/HIC
(long press)
NB: Noise Blanker / ANL: Automatic Noise Limiter. These filters allow reducing
back ground noises and some reception interferences.
HI-CUT: Cuts out the high frequency interferences and has to be used in ac-
cordance with the reception conditions. When active, the filter is displayed
on LCD.
Press NB/ANL/HIC key (8) to
4 positions switch: 1 no filter. 2 only ANL and NB filters activated. 3 only HIC
filter activated. 4 all the filters (ANL, NB and HIC) activated.
Default Value, no filter activated.
Warning: ANL filter works only in AM mode
9) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes the set-
ting of the equipment into the dashboard easier.
See Cabling Diagram page 71.
10) PTT
Transmission key, press to transmit a message,
to listen to an incoming communication.
21
skipping
in and set different function.
MENU
activate the filter or filters.
is displayed and release
200 kHz in
appears