VOSS.farming FM20 WiFi Instrucciones De Operación página 37

INSTRUCTION MANUAL VOSS.FARMING FENCE MANAGER FM20 WIFI
6.6 DETAIL WINDOW - FENCE SENSOR
r - Name and MAC address of the Fence
Sensor
In fo
The name of the device (above) can
be changed by the user.
s - Signal strength between the Fence
Manager and the Fence Sensor
t - Fence voltage value at the relevant point
of the fence [kV]
u - Defined voltage limit value for triggering
the alarm [kV]
v - Battery status of the Fence Monitor [%]
w- Time since last data transmission
7 MOUNTING AND INITIAL SET-UP
7.1 INSERTING THE BACKUP BATTERY
The 9.6 V backup battery is used as a substitute power supply in the event of a mains power failure.
The battery is able to power the device for up to one day. The maximum running time depends on
the device settings (backlight, volume).
1. Open the cover on the rear of the device.
2. Insert the plug of the backup battery into the corresponding socket (7).
3. Insert the backup battery into the designated area (6) and fit the cover back onto the device.
WAR N IN G
There is a risk of explosion if the rechargeable battery is inserted incorrectly.
N OTI CE
Malfunctions may occur if the device is operated without mains power and using
a deeply discharged backup battery. ECO mode is activated if the power supply is
insufficient (see Section 8.4). Only switch on the device once it has been connected
to the power supply.
7.2 MOUNTING THE DEVICE
Select a suitable location for mounting the Fence Manager that meets the following criteria:
∙
Protected against water and moisture
∙
Not in direct sunlight
∙
A power socket (230 V) is available
WAR N IN G
»
Heat build-up may result in smouldering fire. The device must not be covered
by materials etc. during operation as this may lead to a build-up of heat and
possibly to a fire. Therefore, do not install the device in areas where there is
a risk of fire (e.g. hay and straw stores).
»
Mount the device on a fireproof base.
41660 - 11.2022 - V2
DE
EN
FR
IT
NL
SV
ES
37