Publicidad
Idiomas disponibles
Idiomas disponibles
screw threads to ease insertion. For metal
surfaces use a centre punch to mark the
desired hole.
12. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the
load on the machine immediately and release the on/off
switch. Then you can restart the tool soon.
13. TEMPERATURE DEPENDENT OVERLOAD
PROTECTION
When using as intended for the power tool cannot be subject
to overload. When the load is too high or the allowable
battery temperature is too hot, the electronic control
switches off the power tool until the temperature is in the
optimum temperature range again.
14. PROTECTION AGAINST DEEP
DISCHARGING
The Li-ion battery is protected against deep discharging by
the "Discharging Protection System". When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
15. DISPOSAL OF AN EXHAUSTED BATTERY
PACK
To preserve natural resources, please recycle or
dispose of the battery pack properly. This battery
pack contains Lithium batteries. Consult your local
waste authority for information regarding available recycling
and/or disposal options. Discharge your battery pack by
operating your drill, then remove the battery pack from the
drill housing and cover the battery pack connections with
heavy-duty adhesive tape to prevent short circuit and energy
discharge. Do not attempt to open or remove any of the
components.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of
the trigger, is positioned in the lock function. Unlock the
forward/reverse rotation control by putting it into the
required rotation position. Push the trigger and the drill
will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW
IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring,
18
you can find the torque-adjusting ring between the chuck
and the drill body. Position 1 is the lowest torque (screw
driving force) and position 18 is the highest torque (screw
driving force). Position is for drill operation. Regulate
the torque adjusting ring to a higher position to reach the
best result.
3. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in one
direction. Turn the battery around until it can be inserted
into the slot.
4. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and having not used a
battery pack for a prolonged time will reduce the battery
pack working time. This can be corrected after several
charge and discharge operations by charging & working
with your drill. Heavy working conditions such as large
screws into hard wood will use up the battery pack energy
faster than lighter working conditions. Do not re-charge
your battery pack below 0
affect performance.
MAINTENANCE
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
C and above 45
C as this will
o
o
EN
Publicidad
