Angelo Po 10CP1EA Manual De Uso E Instalación página 48

Important
The connection must be made by author-
ised, skilled personnel, in accordance with
the relevant legal requirements, using ap-
propriate and specified materials.
The appliance is supplied with operating
voltage 400V/3N.
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity supply
as follows.
A
G
IT
E
GB
DE
D
FR
ES
Important
Before it is put into service, the system must
be tested to check the operating conditions
of every single component and identify any
malfunctions. In this stage, it is important to
check that all health and safety require-
ments have been complied with in full.
To test the system, make the following checks.
1 - Turn on the water supply tap and check that the
connections are right.
English
ELECTRICAL CONNECTION
F
TESTING OF THE APPLIANCE
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
breaker close to the appliance.
2 - Undo the screws (B) and remove the control
panel (C).
3 - Undo the screws (D) to remove the lid (E).
4 - Fit the power supply cable into the cable gland
(F).
5 - Connect the circuit-breaker (A) to the terminal
board (G) of the appliance as shown in the dia-
gram and in the electrical system diagram at
the back of the manual. Use a cable with at
least H05RN-F characteristics.
6 - Tighten the cable gland (F).
7 - Replace the lid (E) and the control panel (C) on
completion of the operation.
B
B
2 - Check that the mains voltage is the same as
that of the appliance.
3 - Operate the appliance's circuit-breaker to
check the electrical connection.
4 - Check that the safety device is operating cor-
rectly.
After testing, if necessary instruct the user in all the
skills necessary for putting the appliance into oper-
ation in conditions of safety, in accordance with le-
gal requirements.
- 22 -
B
B
C
IDM-39617801400