Vitrifrigo VFP40 Manual De Instrucciones página 20

5. FUNCTION AND OPERATION
1
5
1 Temperature Control
4 ON/OFF
Power supply: connect to DC 12V/24V or AC 100~240V(using dedicated adapter) or solar
(12~50V) power supply.
Display Screen Initialization: when the fridge is powered on, the buzzer will make a long
beep, and the display will be on for two seconds then enter the standby mode.
Power On/Off: press
Temperature Setting: press
automatically after stopping operating for 4 seconds (Note: the temperature displayed is
the current temperature of the compartment, it'll take a while to reach the set temperature.)
Temperature setting range: -20~20°C (-4~68°F)
Cooling Mode: under the running state, press
(Energy saving Mode).(*Factory setting is MAX.)
Battery Protection Mode: under the running state, long press
screen flashes, then press
L(Low) (*Factory setting is H.)
Voltage Reference:
INPUT
MODE
L
M
H
* the voltage is theoretical value, there may be a deviation in different sceneries.
* H should be set when the product is connected to car power, and M or L should be set
when it is connected to a portable battery or other back-up battery.
Temperature Unit Setting: switch off the fridge, long press
E1, and switch to E5 by pressing
Fahrenheit. (*Factory setting is °C.)
Reset: switch off the fridge, long press
long press
20 ENG
2
-20
°C
13.5
ECO MAX HML
2 Led display
5 USB: 5V/1A
to switch ON, long press
or for temperature setting, the setting will be saved
again to select protection mode H(High), M(Medium) and
DC 12V
CUT OUT CUT IN
8.5V 10.9V
10.1V 11.4V
11.1V 12.4V
again, then press
at the same time for seconds to reset the settings.
3
°F
4
3 Set
for three seconds to switch OFF.
to switch MAX (fast cooling) and ECO
CUT OUT
21.3V
22.3V
24.3V
for 3 seconds until displays
or
for 3 seconds until displays E1, under E1 mode,
for three seconds until
DC 24V
CUT IN
22.7V
23.7V
25.7V
to switch Celsius or