Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1.3 Safety requirements for batteries
-Batteries must be avoided in a low voltage state and should be charged as soon as possible. To
avoid leakage of electricity, keep the battery dry and clean, especially to remove
contaminants such as metal dust.
-It is forbidden to put metal parts (such as tools) on the battery to prevent the battery
from being short-circuited and burnt out.
-The charging compartment should be well ventilated.
-When the key switch is in the ON position, it is forbidden to connect or remove the battery
-Before removing or installing batteries, disconnect the negative (-) battery wire and then
the positive (+) battery wire. When rewiring, be sure to pay attention to the polarity of the battery,
as wrong connection will damage electrical components.
-Avoid direct contact between the positive electrode and the negative electrode, because it
will cause a large current short circuit, generate high heat and even cause a fire.
1.4 General Safety Regulations
In addition to the provisions made in this manual, the required general safety regulations and
accident prevention guidelines must also be observed. Even if you have used a similar
sweeper before, please read the instructions carefully. Reading the instructions beforehand will
save you a lot of time in the future. It is important that you become familiar with all
accessories and controls and their functions before you start using them. Please read this
manual thoroughly so that you don't get scrambled when you turn it on.
CHAPTER 2 USE OF THE MACHINE
2.1 Machine keys/pedals
2.1.1The core control keys of the machine
Electricity/Voltmeter (the display device can display the current battery voltage,
please charge when the voltage is lower than 42V).
key switch
sweep button
forward and back buttons
Horn button
headlight button
sprinkler button
Vibration button
V
pay attention:
1) The sweeping button is divided into three gears:
The main brush, side brush and fan at the front block can be started with one key, and the main brush
and side brush will automatically descend, which can be used for cleaning operations;
In the middle gear (debugging gear), the main brush, side brush and fan stop rotating, the main brush
side brush does not rise, and the height of the main brush side brush can be adjusted; the reset gear
main brush side brush lifts.
(2) Dust vibrating button: The dust vibrating function can be used only after the sweeping button is
turned off.
-Sprinkler mechanical valve (be sure to open the sprinkler mechanical valve after
5
Publicidad
