HEIDENHAIN 681046-01 Modo De Empleo página 8

Amplifier for servo motors
Operating Instructions
Connecting a CNC input cable
This product provides an interface connection for CNC control. This connector is for use
with HEIDENHAIN ND 1300 QUADRA-CHEK and IK 5000 QUADRA-CHEK products only.
Use HEIDENHAIN cable ID 540660-56. A label is provided near the connector.
To connect a CNC interface cable:
Verify that the power switch is in the off position
X X
Connect the interface cable to it's connector
X X
Tighten the cable connector screws until they are snug
X X
Connecting a joystick input cable
This product provides an interface connections for a joystick control input. This connector
is for use with HEIDENHAIN joysticks ID 681044-xx only. Use HEIDENHAIN cable ID
540660-53. A label is provided near the connector.
To connect a joystick cable:
Verify that the power switch is in the off position
X X
Connect the interface cable to it's connector
X X
Tighten the cable connector screws until they are snug
X X
7. Power-up
For additional start-up information refer to the documentation provided with the
ND 1300 QUADRA-CHEK, IK 5000 QUADRA-CHEK and any additional accessories or
components that are a part of the system.
To power-up the product:
Press the On (supply) side of the power switch to power-up the amplifier
X X
8. Maintenance
Warning! Risk of danger
A risk of personal injury or death exists if regular inspection and maintenance
tasks are not completed.
Follow the recommended inspection and maintenance schedule to keep the
product in a safe operating condition.
The following inspection and maintenance procedures are required to ensure the product
is maintained in a safe operating state.
Type Part
Visual Power cord
inspection
Visual Symbols and
inspection labels on
product
Visual Product
inspection housing,
keypad and
interface
connections
Electrical Protective
Test ground
connection
8
Interval Possible failure
Annual Damaged insulation,
visible or damaged
wires
Annual Labels and safety
symbols not readable
or not present on
the product. Refer to
"Safety symbols" on
page 4.
Annual Damage or wear
that can affect the
functionality and
safety of the product
Annual Interrupted or bad
connection
Follow up
Replace power cord
Contact a HEIDENHAIN
service technician
Contact a HEIDENHAIN
service technician
Replace power cord or
contact a HEIDENHAIN
service technician
K
9 8 7 6 5 4 3 2 1
18 17 15 14 13 12 11 10
16
26 25 24 23 22 21 20 19
CNC input connector
L
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Joystick input connector