PRESIDENT WALKER II Manual Del Usuario página 35

7) LCD
Indicates transmission
PA PA (Public Address) mode activated
AM
AM mode selected
FM
FM mode selected
UK FM mode selected (only in U configuration / ENG)
ROGER BEEP function activated
BP KEY BEEP function activated
Automatic Squelch Control activated
VOX VOX function activated
SCAN function activated (the dot blinks)
TALKBACK TALKBACK function activated
MENU mode activated
Indicates selected channel (large digits)
Indicates selected band (digits on the top)
Indicates frequency or menu
8) VOX ~ VOX SET
VOX
(short press)
The VOX function allows transmitting
phone (or in the optional vox microphone) without pressing the PTT switch
(17). The use of an optional vox microphone connected to the rear panel
of the transceiver (E) disables
Press shortly VOX key (8) in order to
appears on the display. Press shortly again the VOX key (8) to
function. "VOX" disappears.
by speaking into the original micro-
the original microphone.
activate the VOX function. "VOX"
disable
VOX SET
(long press)
Press the VOX key (8) for 2 seconds in order to
mode.
Three adjustments are possible: Sensitivity SET L / Anti-vox level SET A / Vox
delay time SET T (over and over).
1. change a setting other than the one displayed, press the VOX key (8)
To
to select the next setting or...
2. Turn the rotary PUSH knob (6) or press the UP/DN (18) keys on the microphone
to modify the setting.
3. Press again the VOX key (8) to
4. Once the settings done, press the PTT switch (17) key to
ment mode. If no adjustment is made for 5 seconds, the unit automatically
exits the function.
Sensitivity SET L: allows the adjustment of the microphone (original one or
-
optional vox) for an optimum transmission quality. Adjustable level from1
(high level) to 9 (low level).Default value: 5.
- Anti-Vox A: allows disabling the transmission generated by the surrounding
noise. The level is adjustable. OF (according the squelch level) and from 0
(without anti-vox) to 9 (low level). Default value: 9.
- Delay time SET T: allows avoiding the sudden cut of the transmission by
adding a delay at the end of speaking. The level is adjustable from 1 (short
delay) to 9 (long delay). Default value; 1.
The VOX adjustment does not automatically activate the VOX function.
9) F - FREQUENCY BAND SELECTION
See § FUNCTION TURNING ON THE UNIT page 37.
10) NB/ANL - HIC FILTERS
3 positions switch: Low position: no filter is activated. Central position: only
ANL and NB filters are enabled. High position: all filters (ANL, NB and HI-CUT)
are activated.
NB: Noise Blanker / ANL: Automatic Noise Limiter. These filters allow reducing
back ground noises and some reception interferences.
HI-CUT: Cuts out the high frequency interferences and has to be used in
accordance with the reception conditions.
Note: ANL filter works only in AM mode
11) PRIORITY CHANNELS
the
Priority channels will be automatically
3 positions switch: EMG1/ Priority channel 1 is activated. EMG2 / Priority
35
activate the VOX Adjustment
store and move to next setting...
exit the VOX Adjust-
selected by switching this key (11).