MSW -MTC-350 Manual De Instrucciones página 24

to the bottom of the socket. Finally, insert the lever into the socket and fasten (4).
Use the included mounting hardware, such as screws, for assembly.
The kit includes an auxiliary rod. The thicker end of the rod is used to pull the tire
off the rim and the flat end is used to fit a new tire.
3.2. Working with the device
1. Vent the tire and place the wheel under the lever.
2. Align the spoon with the point where the tire overlaps the rim. Pull down firmly on
the lever so that the spoon removes the tire from the rim. Move the wheel and repeat
in several places as required, then turn the wheel to the other side and pull the tire off
the rim in the same way (5.1 and 5.2).
3. Place the rim and tire on the support on top of the tire changer. Insert the supplied
support rod between the tire and the rim using the thicker end. Roll it over the rim
until the tire comes off completely (3.1 and 3.2).