Descargar Imprimir esta página

Mitsubishi FDT Serie Manual Del Propietário página 11

Ocultar thumbs Ver también para FDT Serie:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 42
Regarding the heating operation
G Heat pump type heating
Heat pump type heating means to heat the indoor air by utilizing the refrigerant to pick up the heat in the
outdoor air.
G Defrosting operation
When heating the indoor air with the heat pump type heating, frost will accumulate on the air inlet of the outdoor
unit as the outdoor temperature drops. Since the accumulated frost reduces the heating efficiency, the operation
is automatically switched to the defrosting mode. During the defrosting operation, the blowers on the both the
indoor and the outdoor units are stopped and the "HOT KEEP" message is displayed on the indication board.
G Outdoor air temperature and heating capacity
During the air conditioning by the heat pump type heating, the heating capacity drops along with the drop of the
outdoor air temperature.
Therefore, it is necessary to operate an additional heating equipment when the outdoor air temperature dropped
excessively.
G Necessary time to raise the indoor air temperature
Air conditioning by the heat pump type heating takes time a little longer because the entire air in a room is
heated by circulating hot air.
You should start the heating operation sufficiently earlier especially in a very cold morning.
HAS THE UNIT BEEN INSTALLED CORRECTLY?
Check the following points for safe and comfortable use of your air conditioner.
Installation is the dealer's responsibility; do not attempt to do it yourself.
Suitable installation position
Don't install the air conditioner near
Install the unit in a well ventilated
a place where inflammable gas may
place.
leak.
This may cause an explosion (ignition) .
Any obstacles may reduce the capacity or in-
crease the noise.
Select a place where the neighbors
You must take snow protection
are not inconvenienced by hot air or
measures if the outside unit is
the noise.
blocked by snow.
Consult your dealer for details.
Electrical works
The electrical works must be burden on the authorized engineer with qualification for electrical works and ground-
ing work, and the work must be conducted in accordance with electric equipment technical standard.
I The power source for the unit is to be of exclusive use.
I An earth leakage breaker should be installed. (This is necessary to prevent electric shock.)
I The unit must be grounded.
I Is the remote control switch properly installed?
G In case of open wiring, is it fixed by the attached screw?
G Is the remote control cord fixed by the attached remote control clamp?
G Is it installed at the height where children can not reach.
For inspection and maintenance
The capacity of air conditioner will decrease by contamination of inside of unit when it is used for about three years
although depending upon the circumstances under which it is used, and so in addition to the usual maintenance
service, special inspection /maintenance service is necessary. It is recommended to make a maintenance contract
(charged) by consulting your sales dealer.
10
Install the air conditioner on a firm
foundation that can well support its
weight.
If you don't, this may cause vibration or noise.
It is advisable not to install the air
conditioner in one of the following
places, as this may cause malfunction-
ing. If, however, there is no other
choice, consult your dealer.
G A place generating corrosive gases (spa
area etc.).
G A place exposed to sea breeze (seaside etc.).
G A place exposed to dense soot or smoke.
G A place with excessively high humidity.
G A place near equipment radiating electro-
magnetic waves.
G A place with excessively wide voltage
variation.
MEMO

Publicidad

loading