Publicidad
Idiomas disponibles
Idiomas disponibles
5. Removing the seat cover (Fig. 5)
a.
Unfasten the Velcro fasteners located on both sides of the top
part of the frame, and then slide it out of the plastic cover.
b.
Take out the plastic element retaining Velcro fasteners.
c.
Remove the hooks located on both sides of the frame as
shown on the picture.
d.
Unhook the two hooks under the seat of the pushchair.
e.
Unfasten the Velcro fastener under the footrest, run it
through the metal tube under the seat and slide the footrest
material off as shown on the picture.
f.
Turn the buckle under the seat so that it can be pulled out as
shown.
g.
Unhook the plastic pieces that connect the fabric to the
frame.
6. Removing the basket (Fig. 6)
a.
Unfasten the Velcro fasteners near the rear wheels, pull them
out of the buckle and away from the pushchair frame.
b.
Unhook the plastic pieces that connect the fabric to the
frame.
c.
Disconnect the pins located on the sides of the basket.
7. Installing/removing the safety bar (Fig. 7)
a.
To attach the safety bar, simply slide the ends of the bar
into the corresponding holes located on both sides of the
pushchair's frame until you hear a locking sound on both
sides.
b.
To remove the safety bar, press the buttons located on either
side of the safety bar.
c.
Pull the safety bar out of the pushchair's frame.
8. Adjusting the footrest (Fig. 8)
a.
To tilt the footrest down, squeeze it at the corners and adjust
the angle.
b.
To raise the footrest higher, simply pull it up gently.
34
Publicidad
