Skiddoü Mell A6 Manual De Usuario página 35

9. Fitting the wheels (Fig. 9)
Insert the front wheels into the corresponding holes in the frame.
When you hear the characteristic "click", this means that the wheel
has been correctly installed.
10. Removing the front wheels (Fig. 10)
a. Press the button above the wheel.
b. While holding down the button, slide out the front wheel.
11. Front wheel lock (Fig. 11)
To prevent the front wheels from spinning, slide down the slider
located above the wheel on the underside of the pushchair. Do this
with both front wheels. To unlock the wheels, move the lock in the
opposite direction.
12. Brake (Fig. 12)
a. To lock the wheels, press the outer part of the brake.
b. To release the wheel lock, press down the inner part of the
brake.
13. Using safety belts (Fig. 13)
a. Press the middle button on the belt buckle to undo the belt.
b. Plastic parts on the belts allow you to adjust the length of the
straps.
c. To fasten the seat belts, insert the respective belts into the
buckle according to the order shown in the figure.
14. Adjusting height of the shoulder belts (Fig. 14)
a. To change the height of the belts, unfasten the Velcro fasteners
located at the bottom, behind the backrest.
b. There are plastic seat belt ends under the sheathing that must
be removed and repositioned in the desired location.
15. Installing the footrest cover, rain cover, mosquito net (Fig. 15)
a. Place the footrest cover over the footrest section, put it over
35