Mig Syn Welding With Wire Feeder - MMA Compacto Serie Manual De Uso

MIG SYN WELDING WITH WIRE FEEDER

16 13 14 15
16B 16C 16D 16A
18 9 10
Figure 8 - Wire Feeder Control Panel - Copy
Selection Key
11
Selection of the 2Stroke / 4Stroke / Spot Welding
Mode / Pause-Work mode (P-W) (Spot LED blinking)
Selection Key
16A
for selecting the available welding parameters:
Current, - LED is lit
16B
Wire Speed,
16C
Thickness 0,6÷25 mm,
16 Left Display
for viewing the parameter selected with key - 16A -
9
Left Regulation Knob
Adjusts the parameter show in display - 16 -
Selection Key
17A
for selecting the available welding parameters:
Voltage, - LED is lit
17B
Arc Voltage Balance,
Operation Point,
Right Display
17
for viewing the parameter selected with key - 17A -
Right Regulation Knob
12
Adjusts the parameter show in display - 17 -
Dynamics
18 Setup Key -
Press key for regulation of the arc dynamics value
(-20% +20%) , use right regulation knob -
setting the parameters.
Save & Recall
19
for saving and recalling the points that the operator
can customize. Refer to the chapter "Save & Recall" .
17A 17B 17C 17D
11 12
- LED is lit
- LED is lit
16D
- LED is lit
17C
- LED is lit
17D
12 -
17
19
for
EN-23