Royal Catering RCIC-80FI Manual De Instrucciones página 24

6. Connection to the water supply hose
7. Connection to the drain hose
8. Drain plug (drainage)
9. Adjustable foot (x4)
3.2.
Preparation for operation
POSITIONING OF THE UNIT
The ambient temperature should not exceed 10-38°C and the relative humidity
should not exceed 85%. Place the unit in a way that ensures good air circulation.
Maintain a minimum clearance of 15 cm from any wall of the unit. Keep the unit
away from any hot surfaces. Always operate the unit on a level, stable, clean,
fireproof and dry surface and out of the reach of children and persons of impaired
mental, sensory and intellectual functions. Place the unit in such a way that the
mains plug can be reached at any time. Ensure that the power supply to the unit
corresponds to that specified on the identification plate!
Before using the unit for the first time, disassemble all parts and wash them as well
as the entire unit.
IMPORTANT: after installing and leveling the unit in its final location, wait 12 hours
before using it for the first time! The same applies to changing the location of the
device.
ASSEMBLY OF THE UNIT
Place the unit in its final location and connect it to a running drinking water supply
(water pressure should be between 1 ~ 7.8 bar) and a sewage drain or a suitable
waste water tank.
NOTE: the drainage hose and its end should be placed below the drainage hole of
the device - this will ensure trouble-free water drainage.
When connecting to the running water supply, be sure to install gaskets on the
connecting parts. The source of the running water should have a valve shutting off
its supply. Then connect the power cord to the power source.
NOTE: the unit can also work with a running water connection equipped with an
external filtering system, but in this case, remember to change the water filter
regularly according to the recommendations of the manufacturer of the installed
water purification system.
3.3.
Working with the unit
NOTE: when starting the machine for the first time or after a long idle
time, unscrew the drain plug and drain the water. During the first 2 cycles