Usage Interruptions; Malfunctioning - Sagi 3241730 Manual De Uso

Clean the exterior and interior surfaces with soap or a neutral detergent and water: a little vinegar added to
the water will eliminate any eventual foul odours.
Before to begin with the operations proceed as following:
- set the general cut-out in OFF position;
- remove the plug from the socket and wait till the complete entfrosting of the unit.
To access the condenser it is necessary to remove the front dashboard:
1. Remove the two upper screws
2. Unhook the dashboard pushing it in a downward direction
WARNING: to assure a regular use of the machine it is necessari to clean the copper-alluminium
condensator at least every 30 days.
Accurately clean the condenser in the refrigerating unit and the inner evaporator with either a vacuum
cleaner, a bristle brush or a non-wire brush after removing the protections.
The cleaning and mantainance operations have now come to end.
In case of longer inactivity of the refrigerator and for maintaining it in the best state act as following:
- set the general cut-out in OFF position.
- remove the plug from the socket.
- empty the refrigerator and clean it as described In the chapter "CLEANING".
- let the door open to avold the forming of bad smell.
Malfunctioning during operation is often due to banal causes , whitch may nearly all be resolved without the
help of a specialised technician. Consequently, before getting in touch with a service centre, check the
following:
PROBLEM
The appliance does not start
The internal temperature is
too high
The appliance is excessively
noisy
Some condensation
produced on the appliance
Upon completion of the above checks, if the fault persists, contact an authorised service centre. Always
indicate:

the nature of the fault

the model and the serial number of the unit can be found on the electrical specifications plaque, located
on the unit's instrument panel.
POSSIBLE CAUSES
Check that the plug is properly inserted into the socket.
Check that there is voltage at the socket
Check the electronic card adjustment
Check for a heat source in the vicinity
Check that the door closes properly
Check that the appliance is standing level. A lopsided appliance could set off vibrations
Check that the appliance is not touching other appliances or parts which could resonate
is Room humidity is very high
The door is not closed properly

USAGE INTERRUPTIONS

18

MALFUNCTIONING