Publicidad
Idiomas disponibles
Idiomas disponibles
Undo the Synchronization of a Single Control
1. Press the SYNC/RST key on the rear panel
of the STM 1003. The mixer's LED will blink
for 15 seconds.
2. Press and hold the POWER
TXM control that you want to remove.
3. The LED of the STM 1003 wil sto blinking.
The control has been successfully removed.
Undo the Synchronization of All Controls
Press the SYNC/RST key on the back panel of the STM 1003 for 5 seconds.
All the controls have been successfully removed.
Low Battery Indicator
When the battery is low, the transmission LED on the control and the LED on the
back panel of the STM 1003 will remain on for 1 second after you release a key
on the TXM control. We recommend that you replace the battery with a new
battery model CR2032, since the control could stop transmitting efficiently.
The TXM transmitter has a system that automatically shuts off any key that is
pressed for more than 10 seconds to avoid unnecessary battery consumption.
When you release the key, the system operates normally again.
Replacing the TXM Control Battery
Remove the Holster, open the back of the control, remove the electronic board
from its plastic housing and replace the discharged battery with a new one. Pay
attention to the indicated polarity, the Clip must be in contact with the POSITIVE
terminal of the battery.
Loss of Synchronism
Loss of synchronization occurs when the TXM control's keys are pressed more
than 250 times while it is out of range of the STM 1003. When this happens,
the STM 1003 stops responding to the TXM control's commands and its indicator
LED blinks permanently. Re-synchronize the control with the STM 1003 to restore
operation.
SYNC/RST Key
key on the
LED Indicator
Press the key
POWER
.
29
Publicidad
