Publicidad
Idiomas disponibles
Idiomas disponibles
▪ The water inlet and the impeller casing are clean.
Starting the pump with accumulated debris can cause
serious damage.
Make all adjustments and work necessary for the correct
assembly of the multistage submersible water pump if you
have any questions or difficulties, contact your official
dealer.
The appliance was designed to pump clean water with a
maximum temperature of 35°C.
Do not, under any circumstances, use the pump with
corrosive, abrasive, easily combustible or explosive
substances (such as petrol, diesel, benzene / thinner),
grease, oils, salt water and sewage (toilets and urinals).
Do not use the pump on water containing sand. Sand
causes and increases pump (especially impeller)
wear and reduces water flow.
The control and safety devices installed on the pump must
not be removed or blocked.
Start-up
Carefully start the pump following the use instructions in
this instruction manual. Following these instructions while
using the pump reduces the risk of injury.
Submersible water pumps are not designed to pump
continuously. Otherwise, the service life will be reduced.
Avoid using the pump if the water outlet is either partially
or completely blocked.
Avoid running the pump dry. Operating the pump without
water, damages the seals. The pump should shut down
immediately if it detects a water shortage.
The pump automatically shuts down if it overheats, which
is detected via overload relay which is inside the motor.
After cooling down, the motor starts automatically.
To switch off, remove the plug from the socket, do not pull
on the power cord.
To avoid frost damage, store the pump in a dry place.
During winter, if the pump is permanently installed
outdoors, check the impeller chamber for the presence of
ice before starting up.
Cleaning:
The pump must be thoroughly cleaned once taken out of
the water.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the water pump.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out all other works must be
performed by an official dealer.
Always keep warning and instruction stickers clean and
legible.
Keep all nuts and screws tight so that the pump is in a safe
operating condition.
If you remove components or safety devices to carry out
maintenance work, they must be replaced immediately and
correctly.
Use only VITO-approved attachable accessories and tools
for this appliance or technically identical parts. Failure to
do so may result in personal injuries or damages to the
multistage submersible water pump.
If in doubt, if you lack knowledge or resources, you should
contact an official dealer.
Your pump should only be serviced by the brand's technical
assistance service, or by qualified personnel, with original
spare parts only.
Publicidad
