Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
4.0 RULES OF USE
To obtain the best performance from the equipment, carefully follow
what is set up below.
ATTENTION
All maintenance work, adjustments and preparation for opera-
tion, must be carried out with the power take-off of the tractor
disconnected, the machine on the ground on its supporting
feet, the tractor not running, the wheels blocked and the key
turned off.
4.1 ATTACHMENT THE TRACTOR
The machine may be attached to any tractor fi tted out with
a three-point universal joint.
The attachment to the tractor is a very dangerous phase.
Be sure to follow the instructions carefully throughout the
operation.
ATTENTION!
LOSS OF EQUIPMENT ON THE ROAD AND OF VEHICLE CONTROL,
DEATH OR SERIOUS INJURIES FOR THE DRIVER AND THE PEOPLE
IN THE VICINITY. Before connecting the equipment to the tractor,
and in any case within 8 hours of continuous use, check the state
of wear and the integrity of the tractor connecting elements and of
the structural elements. The machine cannot be used if anomalies
are noted. Contact your dealer immediately.
4.1.1 HOOKING
The correct tractor/machine position, is determined by placing the
equipment at a distance from the tractor so that the cardan joint
remains extended by 5-10 cm from its maximum closing position.
At this point, proceed as follows:
1) Hook the lifter bars onto the pins provided
the snap split pins. Hook the chains to the lifting bars
2) Connect the third upper point
with the appropriate split pin; use the adjusting tierod
to keep the machine perpendicular to the ground
3) Block the movement of the parallels of the tractor on the hori-
zontal plane using the stabilizers provided, so eliminating the
side swaying of the equipment. Check that the tractor hoisting
arms are positioned at the same height from the ground.
4) Adjust the height of the tractor lifting arms so that, in the tran-
sporting position, the machine does not, for any reason
whatsoever, come into contact with the ground.
5) The hydraulic pipes must be connected correctly to the tractor
distributors following the instructions on each pipe
6) Connect the Cardan shaft and make sure that it is perfectly
blocked on the power take-off
turns freely and fi x it with the chain provided.
During the work, regularly check that the equipment is per-
pendicular.
ATTENTION: Always follow the indications recommended by
the Manufacturer for the transport of the machine.
56 - EN
USE AND MAINTENANCE
DANGER
(1, fi g.8)
(2, fi
g.9); the pin will be blocked
(fi g.9)
(fi g.11).
Check that the guard
fi g.8
fi g.9
Block with
(3, fi g.9)
(fi g.10).
fi g.11
1
3
2
90°
90°
cod. F07011381
fi g.10
Publicidad
