Troubleshooting Guide; Warranty - Altrad Belle GROUP RANGER 450 Manual Del Operador

Problem
Engine will not start.
Blade not turning.
Excessive Noise,
Vibration or wobble
from blade.
Your new Belle Group Ranger Floor Saw is warranted to the original purchaser for a period of one-year (12 months) from the original
date of purchase. The Belle Group warranty is against defects in design, materials an workmanship.
The following are not covered under the Belle Group warranty:
1. Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow assembly,
operation or user maintenance instructions.
2. Alterations, additions or repairs carried out by persons other than Belle Group or their recognised agents.
3. Transportation or shipment costs to and from Belle Group or their recognised agents, for repair or assessment against a warranty
claim, on any machine.
4. Materials and/or labour costs to renew, repair or replace components due to fair wear and tear.
The following components are not covered by warranty:
• Drive belt(s)
• Engine air ¿ lter
• Engine spark plug
Belle Group and/or their recognised agents, directors, employees or insurers will not be held liable for consequential or other damages,
losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
All warranty claims should ¿ rstly be directed to Belle Group, either by telephone, by Fax, by Email, or in writing.
For warranty claims:
Belle Group Inc,
Electric Road SW,
Suite 360,
Roanoke, VA
24018,
USA
Tel : +1-540-345-5090

Troubleshooting Guide

Cause
No fuel getting to engine.
Engine switched off.
Engine cold.
Engine À ooded.
Belts incorrectly tensioned
Belts broken.
Check condition of arbor
shaft bearings
Check dowel pin for damage
Check tightness of arbor shaft nut.
Check condition of Blade À ange.
Check Blade for signs of damage.
Fax : +1-540-345-5091
Remedy
Open fuel tap.
Fill fuel tank.
Switch engine on.
Close choke.
Honda: Open choke, fully open throttle, pull recoil starter
until engine ¿ res.
Lombardini: Move Engine speed controller to stop,
pull recoil starter 5 times then repeat start procedure.
Re-tension belts.
Replace belts.
Replace as necessary.
Replace dowel pin.
Tighten as necessary.
Replace as necessary.
Replace blade.

Warranty

Email : bellegroupinc@aol.com
21