TZS First AUSTRIA FA-5104-1 Manual De Instrucciones página 2

IMPORTANT SAFETY INSTRUCTIONS
The safety of electrical appliances from FIRST
Austria complies with the recognized technical
directives and legal regulations for safety.
Nevertheless, you and the other users of the
appliance should observe the following:
• Please read these instructions carefully before
using this appliance for the first time and
keep them for further reference.
• This product has not been designed for
any other uses than those specified in this
manual.
• Before connecting the appliance to the
power source, check if the voltage indicated
on the appliance corresponds with the
mains voltage in your home. If this is not the
case, contact your dealer and do not use the
appliance.
• If the appliance is grounded (protection class
I), the wall outlet and any extension to which
it is connected must also be grounded.
• Place the appliance on a clear, flat and heat-
resistant surface. Distance from the wall
should be at least 5 cm. The area above the
appliance should be kept free to allow an
unobstructed air-circulation. Never place the
appliance or power cord on hot surfaces. Nor
should the appliance be placed or operated
in the vicinity of exposed gas flames.
• Do not let the cord hang over the edge of a
table or counter. Do not let the cord touch
hot surfaces.
• Do not operate or place any part of this
appliance on or near any hot surface (such as
gas or electric burner or a heated oven).
• Ensure that the appliance is used on a firm
and flat surface out of reach of children, this
will prevent from overturning and avoid
damage or injury.
• To protect from electrical hazard, do not
immerse this appliance or cordset in any
liquids.
• If the appliance or the power cord shows
any signs of damage, do not operate it! Take
the product to an authorized and qualified
service center for inspection or repair.
• The ventilation openings must be kept free.
• Make sure the appliance is switched off
before plugging in or unplugging the device.
• Do not operate the appliance with wet hands.
• The use of attachments not recommended
or sold by the manufacturer may cause fire,
electric shock or injury.
• This device is intended for home use only, do
not use it commercially.
• Do not use this appliance outdoors.
• Do not leave the appliance unattended while
it is operating.
• Do not touch the evaporator to avoid
frostbite.
• Always disconnect the appliance from the
power source before draining the water.
• Always disconnect the appliance from power
after use, before cleaning and in the event of
a malfunction.
• Do not pull directly on the power cord, rather
pull on the plug to disconnect the appliance
from the power source.
• The appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by children
unless they are older than 8 and supervised.
Keep the appliance and its cord out of reach
of children less than 8 years.
• We are excluded of liability for all damages
that may arise if the appliance is used for
purposes other than originally intended or if
it is used inappropriately.
• Repairs and other work undertaken on
the unit must only be done by authorised
specialist personnel!
KNOW YOUR ICE CUBE MAKER
Fig. A
1. Drain Plug
2. Lid
3. Control Panel
4. Water Reservoir
5. MAX Water Level Mark
6. Evaporator
7. Ice Tray
8. Ice Basket
9. Ice Scoop
10. Carrying Handle (FA-5104-2 only)
2
CONTROL PANEL Fig. B
Button/Indicator Function
"ON/OFF" Button To start or stop the appliance.
"POWER" In standby mode: The "POWER"
indicator is flashing.
During operation: The "POWER"
indicator lights up continuously.
"ICE FULL" This indicator lights up when the
ice basket is full.
"ADD WATER" This indicator lights up when the
water reservoir needs to be refilled
with water.
"SMALL" This indicator lights up when small
ice cubes are selected.
"LARGE" This indicator lights up when large
ice cubes are selected.
"SELECT" Button In standby mode: To select between
"SMALL", "LARGE" or "CLEAN".
During operation: To select
between "SMALL" or "LARGE".
BEFORE FIRST USE
Important! The inclination angle of the ice
cube maker should not exceed 45° during
transportation or use. Do not turn the ice cube
maker upside down. Doing so could cause the
compressor or refrigeration system to operate
incorrectly. Please wait for about 2 hours to
allow the fluids in the compressor to settle
before using it for the first time. Do not use the
appliance in cold environments below 5°C.
1. Unpack the appliance and make sure that all
accessories are complete.
2. For FA-5104-2 only: Install the carrying
handle (10):
Pull the handle apart slightly and insert it into
the corresponding openings of the housing.
Check that the handle properly snapped in
place.
3. Place the ice cube maker on a dry and level
surface in a suitable place with sufficient
ventilation.
4. Clean the appliance by following the steps of
the chapter "CLEANING & MAINTENANCE"
OPERATING INSTRUCTIONS
1. Ensure that the drain plug (1) at the bottom
of the unit is properly closed.
2. Connect the ice cube maker to the wall
outlet.
Note: Let the unit rest for 30 minutes after it has
been moved.
3. Open the lid (2) and remove the ice basket
(8).
4. Fill the water reservoir (4) with drinking water.
Do not exceed the MAX water level mark (5).
5. Insert the ice basket and close the lid.
6. Press the "SELECT" button to choose the
desired ice cube size, then start the process
by pressing the "ON/OFF" button.
Note: The standard ice-making cycle takes
about 7-9 minutes, depending on the ambient
temperature, water temperature and selected
ice cube size. The ice making cycle starts by
pumping water into the ice tray, which is
located under the evaporator. Over the next
7-9 minutes ice forms on the evaporator. Once
this is completed, the ice tray tilts back and
the remaining water in the ice tray flows back
into the water reservoir. The ice cubes are then
dropped from the evaporator and pushed into
the ice basket. The ice tray automatically returns
to its position and the next cycle starts.
7. The "ICE FULL" indicator will light up when the
ice basket is full. In this case, the ice-making
cycle stops automatically. Gently remove the
ice from the ice basket with the ice scoop (9).
The ice cube maker will restart its ice making
operation automatically.
8. The "ADD WATER" indicator will light up when
the water reservoir needs to be refilled with
water. In this case, the ice-making cycle stops
automatically. Remove the ice basket, fill
water into the water reservoir, and then press
the "ON/OFF" button to restart the ice-making
cycle or it will restart automatically after a
certain time.
9. When you have got your desired amount of
ice, stop the ice making cycle by pressing the
"ON/OFF" key and unplug the power cord
from the wall outlet. Open the top lid and
transfer the ice to a freezer.
Note: Please empty the water reservoir if the
ice cube maker is not used due to hygienical
standards.
3