Publicidad
Idiomas disponibles
Idiomas disponibles
Thermoforming
(pay attention to the
1.) Selected foil
Correct foil?, if yes, confirm.
In the display further working
steps are indicated. The visu-
alisation disappears with the
next step. If necessary, move
support for foil frame in the
upper position.
Put the selected foil in the foil
reception and fixate with foil
securing ring.
Now or during the heating
process embed the model in
the granules.
Push form pot with model
into the unit until it clicks into
place.
notes):
2.) Foil will be heated
Place foil reception with
foil onto the insertion ramp
and push it that far under
the heater until it clicks into
place.
The
foil
temperature
appears in the display, the
foil is heated.
The function field »X«
aborts the heating
process and leads back
to display view 1.
If the foil is pulled out of
the heating area (max. 3
sec., otherwise the heating
process will be stopped),
the working steps described
under "to 1." appear again in
the display.
When the rated
temperature is reached,
the heater switches off.
3.)
Attention, thermoforming
process
10 °C before reaching the
rated temperature, a signal
sounds and a warning sign
flashes.
As soon as the
rating temperature is rea-
ched, the thermoforming
process will be automati-
cally released.
Do not reach into the unit!
Risk of crushing!
Risk of
serious injuries.
NOTES:
The function field »X« aborts
the respective process.
Each termination has to be
confirmed.
If within 10 seconds the
next required working step
is not performed, the
working program will be
switched off for
safety reasons.
4.) Cooling time
to 4. After thermoforming the
cooling time runs down.
Afterwards further working
steps are indicated on the
display.
Pull form pot out of the
unit. In doing so the red
protection
shield
moves
upwards.
Take model and foil out of
the foil reception.
error 001: blocked
support for foil
reception, see page 30.
GB
25
Publicidad
