Publicidad
Idiomas disponibles
Idiomas disponibles
Before use
Add detergent and rinse aid
The rinse aid is released during the last rinse to prevent water from forming droplets on the dishes, which
can leave stains and streaks. It also improves drying by allowing the water to run off the dishes. Your
dishwasher is designed to use liquid rinse aids.
WARNING! Only use rinse aids approved for use in the dishwasher. Never fill the rinse aid
dispenser with other substances (e.g. dishwasher detergent, liquid detergent). This will damage
the product.
When should I refill the rinse aid dispenser?
Unless the rinse aid warning light (
from the colour of the optical level indicator next to the cap. When the rinse aid tank is full, the indicator
will be completely dark. The size of the dark spot decreases as the rinse aid decreases. You should never
let the level of the Never let the rinse aid level fall below 1/4 of its capacity.
As the rinse aid decreases, the size of the black dot on the rinse aid level indicator changes, as shown
below. rinse aid level indicator changes, as illustrated below.
What is the function of detergent?
The chemical ingredients that make up the detergent are necessary to remove, spray and dissipate all
soiling from the dishwasher. Most commercial grade detergents are suitable for this purpose.
suitable for this purpose.
WARNING! Use only detergent specifically manufactured for dishwasher use. Keep the detergent
in good condition and at room temperature.
Do not put detergent in the dispenser until you are ready to wash the dishes.
Dishwashing detergent can be corrosive. Keep dishwashing detergent out of the reach of
children.
Filling the rinse aid tank
1
Lift the cap of the rinse aid
reservoir.
Adjusting the rinse aid tank
To achieve better drying performance with less rinse aid, the dishwasher is designed for the user to ad-
just its consumption. Follow the steps below.
1. Switch on the product.
2. Within 60 seconds after step 1, press the Programme button for more than 5 seconds and then press
the programmed start button to enter the setting mode, the rinse indication flashes at a frequency of 1
Hz.
3. Press the Programme button to select the appropriate programme according to your usage habits,
the programmes will change in the following sequence:
D1->D2->D3->D4->D5->D1.
The higher the number, the more rinse aid the dishwasher will use.
4. If no operation is performed for 5 seconds or the On button is pressed to exit the setting mode, the pro-
cess is successful.
) on the control panel is on, you can always estimate the amount
Carefully pour the rinse aid into
2
the rinse aid dispenser, preven-
ting it from overflowing.
54
3
Close the lid.
English
infiniton.es
Publicidad
