Fein SuperCut Instrucciones De Manejo página 11

3 41 00 981 06 1 - Buch Seite 11 Montag, 10. November 2003 8:20 08
SuperCut
Operating instructions.
Cutters for the vehicles sector.
The cutters for the vehicles sector are to
be mounted as shown in the enclosure.
A Cutters, straight and curved.
B Cutters, bent at right angles.
C Cutters, U-form.
D Scraping knife.
E Scraping knife.
F Cutter with tappet guide.
The straight, curved or right-angled cut-
ters must be held at right angles to the
window flange.
With the U-shaped cutters make sure that
the base of the cutter is guided parallel to
the vehicle windscreen.
The scraping knife serves for levelling out
glue spots on the window flange or wind-
screen. Before re-gluing the vehicle wind-
screen, the remaining bonding is to be
levelled to approx. 2 mm.
Cleaning and care.
!
Risk of injury
by switching the tool ON unintentionally.
Before cleaning, pull out the mains plug.
Carry out the following once a week, or
more often if the power tool is used more
frequently:
Clean the venting openings.
Blow out the motor space from outside
with dry compressed air.
Maintenance and repairs.
!
Risk of injury
Service, testing and repairs may only be car-
ried out by electrical engineers in conformity
with the regulations valid in the respective
country.
Maintenance and repairs.
We recommend our customer service
department (repair centre), FEIN author-
ised service centres and agencies.
Addresses can be found at the end of
these operating instructions and in the
enclosed safety instructions.
Please hand these operating instructions
to the repair centre. An overview of spare
parts can be found at the end of these
operating instructions.
Only use original FEIN spare parts.
Spare parts.
The overview of spare parts is at the end
of these operating instructions. Quoting
the parts no. (1), reference no. (2) as well
as the number of spare parts (3) facilitates
the ordering procedure.
Accessories.
The following sets of accessories are avail-
able for equipping the machine for the first
time:
- Window mounting
- Joinery/interior decorating
- Tile laying/furnace construction/
installing
- Repairing joints
- Vehicle workshops, car glazier
Further information on their application
are contained in the sets of accessories.
EN
11