appliance and the wall, 7.5 cm from rear wall, and leave 30
cm between the top of the appliance and the ceiling. An
incorrect location could increase the noise of the device.
• Choose a place that is not exposed to sunlight, high
temperature or humidity, since moisture can cause stains.
• REMOVE the lower panel before installation.
• The appliance can be adjusted by rolling its two legs in when
it is unstable. Rolling clockwise.
• This appliance is designed to operate in ambient temperature
between 16°C and 38°C. If these temperatures are exceeded
(colder or warmer), temperature inside the appliance may
vary regaring what user established.
• If the device is turned off for any reason, wait 10 minutes
before turning it on again. This will allow the pressures in the
cooling system to equalize before restarting.
• Turn off the appliance and unplug it from the main socket.
Remove all food.
Your appliance uses isobutane (R600a) as a refrigerant.
Although R600a is an environmentally friendly and natural
gas, it is explosive. Therefore you should be careful during
shipment and installation to prevent your appliance's cooler
elements from being damaged. In the event of a leak caused by
damage to the cooler elements, move your fridge from open flame
or heat sources and ventilate the room where the appliance is
located for a few minutes.
REVERSIBLE DOORS
The side to which the refrigerator door opens can be changed from
the right side to the left, if the place of installation requires it.
WARNING: In case of changing the door, make sure that the
appliance is completely turned off and disconnected from the
power
supply.
35