Descargar Imprimir esta página

Denver CAD-474BT Manual De Instrucciones página 23

Ocultar thumbs Ver también para CAD-474BT:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 63
WIRE CONNECTION
RCA Line Out:
Red (right) White (left)
CONNECTOR A
4. MEMORY +12V
5. AUTO ANTENNA OUTPUT
7. +12V (TO IGNITION KEY)
8. GROUND
Note: (connector A no. 7) must be connected by car ignition key
in order to avoid that car battery being drained when
the car will be not used for long period.
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
Maintenance
FUSE REPLACEMENT
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after the
replacement, there may be an internal malfunction. In this case, consult your nearest repair center.
Warning
Use the specified amperage fuse for each lead. Use of a higher amperage fuse may cause serious damage.
INSTALLATION
PRECAUTIONS
Choose the mounting location carefully so that the unit will not interfere with the normal driving functions
of the driver.
Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight
or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration.
Use only the supplied mounting hardware for a safe and secure installation.
Be sure to remove the front panel before installing the unit.
NOTE: Inclination angle for car radio installation must not
exceed 30˚ otherwise the front panel will not open.
1
1
release screw and
bracket
2
Note:
Keep the release key in a safe place as you may need it in the future to remove the unit from the car.
ANTENNA
CONNECTOR
2
3
182mm
LINE OUT
L(WHITE) R(RED)
3
TAP
53mm
Bend these
claws, if necessary
EN-3
FUSE 10A
ISO CONNECTOR
1 3 5 7
B
2 4 6 8
5 7
A
4
8
BLUETOOTH ANTENNA
CONNECT TO
EXTERNAL MICROPHONE
182mm
4
53mm

Publicidad

loading