Using The Operating Manual; Basic Safety Instructions; Responsibilities; Notes On Setting Up And Operating The Tool - TE Connectivity AWG14 Manual De Instrucciones

PN 9-744010-7
1

Using the operating manual

The operating manual must be constantly within reach of the tool.
Each person entrusted with the job of operating the tool must be familiar with the operating manual and
strictly observe the instructions therein.
TE Connectivity decline to accept any liability for damages that are incurred due to the fact that the
instructions on the tool or in the operating manual have been disregarded.
The user is responsible for supplementing the operating manual with any instructions resulting from
current national regulations for accident prevention and protection of the environment.
2

Basic safety instructions

The tool has been constructed according to state-of-the-art technology and the acknowledged technical
safety regulations.
When carrying out jobs such as installation, commissioning, set-up, operation, changing the conditions of
use and the mode of operation or carrying out maintenance and service jobs, it is important to observe
the procedures described in the operating manual.
RoHS information
Information on the presence and location of any substances subject to RoHS (Restriction on Hazardous
Substances) can be found at the following website:
http://www.tycoelectronics.com/customersupport/rohssupportcenter/
Click on "Find Compliance Status..." and enter equipment part number.
2.1

Responsibilities

The tool may only be operated by suitably trained and authorized personnel.
The user must clearly define and observe the responsibilities of the personnel for operation, set-up,
maintenance and service.
It is particularly important to define who is responsible for work on the equipment. Such work should only
be carried out by specially trained staff.
Should the user make any changes to the tool without consulting the manufacturers or the suppliers, the
latter will not be liable for any damage that may result.
2.2

Notes on setting up and operating the tool

The tool may only be set up and operated in perfect technical condition, observing all the safety
regulations and considering any possible dangers.
If you suspect that the tool cannot be operated safely, it must be put out of operation.
The tool may only be used for the purpose specified in the operating manual.
The manufacturers and suppliers will not be liable for any damages which may result due to the tool being
used for a purpose other than that for which it was intended. This is done entirely at the user's own risk.
Page 13 / 47
411-18315 Rev. H
ECOC: EGC0 ; LOC: AI